WAVEWALK KAYAKS

Kevin Eastman, a kayak fly angler from Florida, already contributed the story about the wooden Greenland-Aleutian paddle he made, and a suspended storage solution for his W500 fly fishing kayak.
Since then, Kevin has introduced some improvements to his W500:

-”I snapped a couple of photos of the mounting I did for the bilge pump and the plastic clamps I used under the screws. I also have a simple PVC rod rack that some might be interested in looking at. It’s similar to one that I saw on pictures of Jeff’s before the short rods, but more slender. The pieces on the seat can be added to the ends for more rod storage or positioned for trolling. The two holders on top are cut out for holding fly rod set ups and work well.
Kevin”

Sometimes you might need to drain water from the bottom of your fishing kayak, for example if a big wave breaks right on top of it, or if you capsized it and it overturned.

Whitewater canoeists and kayakers as well as touring kayakers use either bilge buckets or bilge pumps for this purpose.

This DIY hand bilge bucket is easy to make, lightweight, and above all – effective.

You can use any 1 gallon plastic bottle (E.G. milk bottle, water bottle) to make such a bucket – Just cut the bottom and secure the cap so it won’t fall, and you’re all set.

This square, 1 gallon standard size fits the width of the W kayak hulls perfectly, which makes such a bucket more efficient.

Naturally, you should attach the bucket to your kayak, so that you can find it when you need it…

You’re planning to take your W kayak on a fishing or paddling trip in the ocean, and you may be asking yourself what’s going to happen if you have to launch it in big surf, and in such case how to protect yourself from getting wet.
Indeed, if you’re launching in big surf some spray might get the inside of your W kayak wet, and even splash you. This is why all 2008 W Kayak models come outfitted with a preparation for a cockpit cover:
You can use any waterproof fabric or plastic sheet to cover the front part of your W kayak cockpit and thus prevent spray from getting in. Once you’re past the breakers you can easily remove the cover, fold or roll it, and store it in the cockpit or on top of the hulls

This picture shows the cover protecting almost the entire cockpit, leaving some place for you to sit in the back, which is where you want to be when launching in big surf:

This picture shows the cockpit cover protecting just the front part of the cockpit. This is a preferable when you’re positioned in the middle of the cockpit:

Normally, even without a cockpit cover spray shouldn’t be a problem at all since if some spray gets in the water will be drained from the saddle to the bottom of the hulls, and you won’t have to sit on a wet surface.

If you’ve had some bad encounters with big breakers while not using a cockpit cover and there’s too much water in the bottom of the hulls for you to feel comfortable with you can easily drain it using a small bucket or a kayak bilge pump. Then you can dry the hulls completely with a sponge.

Unlike SOT kayaks, the structure of the W kayak enables you to clearly see the bottom of the hulls, and therefore water can’t be there without you perceiving it.

Similarly, when you’re going paddling in fast streams and you want to keep dry you may find the cockpit cover to be useful – without it getting you entrapped in your boat like a traditional kayak spray skirt might.

The W kayak cockpit cover is also useful in case the weather changes suddenly and you get caught in heavy rain, and it offers protection against cold wind.